By Ester Shaffer. Measuring Tools. Published at Saturday, December 02nd, 2017 - 09:12:52 AM.
Magmeters, vortex meters, and turbine flow meters have serious down time for installation and can pollute a system. A portable flow meter does the exact same job with no risk of these things happening. There is no drop in pressure, no moving parts, and no risk of leaks. Once in place, a portable flow meter is completely maintenance free. The other huge advantage of using a portable flow meter is that it can be moved from site to site and be used to measure different parts of the pipe. Traditional flow meters do not offer this advantage. In addition, a portable ultrasonic flow meter is at least if not more accurate than the alternative methods. The reason for this is simple; it does not change the active system in any way while it is in operation. Hopefully this has helped to give you an idea of what a portable flow meter can do for you. The only way to really see how useful these tools are is to get one for yourself and try it out. Luckily for the most part the tools are not that expensive and can measure a wide variety of pipes.
How to Measure! Measuring for a new blind is straightforward and simple. What you will need A tape measure. Metal ones are the best! A pen and piece of paper Handy hints Take all your measurements in centimetres (cm) to the nearest 0.1cm. Always look out for things like window handles or tiles. Youll need to take their position into account to ensure a perfect fit. All our blinds can be fitted into the face of your window frame or wall, or into the top of the lintel. This gives you complete control over the positioning of your blind. Important note for measuring Roller blinds! For Roller blinds, we have to allow for fittings at either end of the blind, as there is no headrail. This means the actual fabric is approximately 2.8cm less for an exact measurement and 3.3cm less for a recess measurement. You dont need to make this adjustment, we do.
Then determine which way you want to run the floor. That means when you are looking at the room do you want the flooring to run horizontal or vertical? Trying to run the flooring diagonally is a great look but you should only try it if you pretty handy and have a lot of patience because it will require a lot of miter cuts. Now you are ready to lay the underlay. This should lie side by side, do not overlap it. Start in the center of the room. Pergo has made their wood flooring easy to use, it has a pre-glued tongue and groove system and it literally just snaps together, you can use a mallet just to tap the ends to make sure that the seam is tight. From the center of the room snap together your next piece on the short sides and continue all the way across the floor. For your next row do not line it up with the first piece perfectly, offset it. Otherwise, you will get a seam line and a noticeable repeated pattern. When you get to the edges and they are up against an object, a pull bar comes in handy so that you can still keep the seams tight.
Any content, trademark’s, or other material that might be found on the CoolAt website that is not CoolAt’s property remains the copyright of its respective owner/s. In no way does CoolAt claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 CoolAt. All Rights Reserved.