Published at Wednesday, April 11th, 2018 - 18:20:52 PM. . By Carla Preston.
The next step is mixing the Cerlon. This is done in 5 gallon buckets using the buckets that the Cerlon comes in take and pour ½ of the Cerlon in a clean bucket and mix the product half at a time. The most important part of mixing Cerlon is the ratio of water to the Cerlon has to be measured very accurately. A paddle on an electric drill that you use from mixing taping compound or floor leveler can be used to mix the Cerlon.
I called Brian the certified installer for the Cerlon product and showed him the problem. We decided that we could repair any of the aprons in the project that needed to be repaired using Cerlon. The aprons are 18” wide by the length of the door. We snapped a line half the width of the garage door thickness. We then installed a diamond masonry cutting blade on a skilsaw and cut a ¾” deep cut along the chalk line. The next thing we did is every 3 inches we scored the concrete the length of the door ¾” deep.
Any content, trademark’s, or other material that might be found on the CoolAt website that is not CoolAt’s property remains the copyright of its respective owner/s. In no way does CoolAt claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 CoolAt. All Rights Reserved.