By Georgette Porter. Concrete Tools. Published at Monday, February 26th, 2018 - 20:24:52 PM.
The next step is mixing the Cerlon. This is done in 5 gallon buckets using the buckets that the Cerlon comes in take and pour ½ of the Cerlon in a clean bucket and mix the product half at a time. The most important part of mixing Cerlon is the ratio of water to the Cerlon has to be measured very accurately. A paddle on an electric drill that you use from mixing taping compound or floor leveler can be used to mix the Cerlon.
You can mix a batch of Cerlon at a time then trowel it because Cerlon will adhere to itself even if it is set without causing a cold joint. Cerlon sets in 10 minutes. Cerlon when setting the temperature reaches in excess of 140 degrees. In my opinion Cerlon to patch concrete is best product to use to eliminate salt from damaging the Concrete. Cerlon also sets fast so there is little or no down time on the area to be repaired. The only down side to Cerlon is the need for training so that Cerlon does not harden before you can finish it.
Year-Round Repairs - Polyurethane repairs can be done in most any weather. Provided the driveway can be dried before you begin, there is no need to worry about temperatures. FlexSet can be ordered with a catalyst for use in cold weather. With traditional repairs- patching concrete driveways using concrete driveway crack filler, driveway concrete sealer and driveway cold patch, the weather must be right and even with the best weather, it can take a minimum of five days wait before you can park again. With FlexSet, your concrete driveway repair will set up in under an hour regardless of humidity or cold.
Any content, trademark’s, or other material that might be found on the CoolAt website that is not CoolAt’s property remains the copyright of its respective owner/s. In no way does CoolAt claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 CoolAt. All Rights Reserved.