Published at Thursday, April 12th, 2018 - 09:35:52 AM. . By Marquita Sanford.
I called Brian the certified installer for the Cerlon product and showed him the problem. We decided that we could repair any of the aprons in the project that needed to be repaired using Cerlon. The aprons are 18” wide by the length of the door. We snapped a line half the width of the garage door thickness. We then installed a diamond masonry cutting blade on a skilsaw and cut a ¾” deep cut along the chalk line. The next thing we did is every 3 inches we scored the concrete the length of the door ¾” deep.
You can mix a batch of Cerlon at a time then trowel it because Cerlon will adhere to itself even if it is set without causing a cold joint. Cerlon sets in 10 minutes. Cerlon when setting the temperature reaches in excess of 140 degrees. In my opinion Cerlon to patch concrete is best product to use to eliminate salt from damaging the Concrete. Cerlon also sets fast so there is little or no down time on the area to be repaired. The only down side to Cerlon is the need for training so that Cerlon does not harden before you can finish it.
Any content, trademark’s, or other material that might be found on the CoolAt website that is not CoolAt’s property remains the copyright of its respective owner/s. In no way does CoolAt claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 CoolAt. All Rights Reserved.